1. Introduction

The following kowledgebase article gives access to an ARGUS demo site and guides through the logging in process and then the basic navigation through the site.

2. Site details and Logging In

Firstly go to:

http://www3.soil.co.uk/itmsoil_demo/

You will be presented with the login screen (see Figure 1.) Enter the following details:

Username: support

Password: demo1

Figure 1. Login Screen

Once the details have been entered select "Login" and you will be taken to the demo project main page (see Figure 2). The left had toolbar is used to navigate around the project. The "Select Planview" dropdown box is used to select planviews which are set up specifically for each project. Select the "Joint and Strain" planview (circled on Figure 2.).

Figure 2. Main screen - plan view selection highlighted

Once you have navigated to the plan view sensors will be shown within green boxes (see Figure 3.).

Figure 3. Plan View

 

Clicking on the current value of a sensor will produce a new window displaying a graph for that sensor (see Figure 4.).

Figure 4. Sensor Plot

If you have any further queries, please submit a ticket on the support site or call Soil Instruments on +44 01825 765044 for advice.

Checked MO'R v1.0 20/05/15